Automatic Needle Threader - Singer 85SCH Instruction Manual

EN

Automatic Needle Threader

- Thread upper tension of machine up to the thin wire in front
of the needle clamp.
- Raise the needle to its highest position.
- Set the Pattern Selector Dial (see item # 13 on page 2 of
the manual) to Straight Stitch.
- Set Stitch Width Dial (see item # 11 on page 2 of the
manual) to "0".
- Set Three Needle Position Dial (see item # 9 on page 2 of
the manual) to center position.
- Lower the needle threader (A) as far down as it will go,
then push it back gently so that the hook inside the
threader will slip into the eye of the needle.
- The threader automatically swings to the threading position (B).
- Pass thread under thread guide (C), from left to right.
- Pass the thread in front of the needle around the hook (D)
from bottom to top.
- Release lever (A), by swinging it away from you & then
pushing it back up to the resting position.
- Pull the thread through the needle eye.
Attention:
Turn power switch to off ("O")!
The needle threader is designed to work best with a size 14
needle. Your machine is equipped with a standard size 14
needle at the factory.
A
1
A
2
18
B
D
C