Dometic RM1350 Operating Instructions Manual page 12

INSTRUCTIONS FOR USE
ADJUSTING THE SIZE OF CUBES
If the ice maker was cleaned and drained, no ice
cubes will be dumped into the bin during the first
cycle.
The first few cycles may have small cubes due to air
trapped in the water lines. The first container of ice cubes
should be dumped if the water system has been winter-
ized or not used for several weeks. Once the ice mak-
er has run through several cycles and if cubes are too
small or sticking together, adjustment is necessary on the
amount of water entering the mold.
TO ADJUST THE SIZE OF CUBES, FOLLOW THESE
STEPS:
1. Remove the protective cover from the ice maker
mechanism. Using a flat-head screwdriver, place
the tip of the screwdriver in the slot. Twist the
screwdriver blade gently to loosen the cover.
2. Locate the adjusting screw under the protec-
tive cover. Turn the screw counterclockwise to
increase the size of cubes.
Adjusting screw
Cover
3. Turn the screw clockwise to decrease the cube
size or if the mold is overfilling, and the cubes
are stuck together.
To prevent overfilling, do not turn the adjustment
screw more than one revolution at a time. Allow
the ice maker to cycle several times before another
adjustment is made. Be sure to replace the protec-
tive cover on the cycle after the adjustments are
complete.
DISPENSER(S)
RM1350WIM
Water Only
If new installation or used for the first time after the RV has
been winterized/put into storage, the water tank, located
inside the refrigerator, must be filled with water.
TO FILL THE TANK WITH WATER, FOLLOW THESE
STEPS:
1. Verify that the water valve supplying the refrigera-
tor is turned on.
2. Insert a glass and press the water dispensing
lever for approximately 20 seconds.
3. Pull glass away.
4. Repeat steps 1 and 2 until water begins dispens-
ing.
WATER DISPENSER
RM1350WIM
TO DISPENSE WATER, FOLLOW THESE STEPS:
1. Insert a glass in the dispensing cavity and press
the lever. This will activate a switch which turns
on an electric water valve at the back of the re-
frigerator. Water will flow through a separate tube
and out of the dispenser.
2. To stop dispensing, pull glass away from the
lever when 3/4 the desired amount has been
dispensed.
If new installation, or used infrequently, dispense
numerous glasses of water before use. To keep the
water fresh, it is recommended to use the dispenser
- 12 -
every day.
(RM1350WIM & RM1350WID)
RM1350WID
Ice / Water
(RM1350WIM & RM1350WID)
Water
RM1350WID