Yaesu FT-450 User Manual page 6

YAESU HF/50 mHz Transceiver FT-450 User's Manual
CONTROL ACT
ON/OFF T-PRESS -
DSP PRESS
ATT/IPO PRESS
T-PRESS CW
NB PRESS
AGC PRESS
T-PRESS -
BAND▼ PRESS
BAND▲ PRESS
TUNE PRESS
T-PRESS -
F PRESS
T-PRESS
METER/DIM PRESS
T-PRESS -
MODE▼ PRESS
T-PRESS
MODE▲ PRESS
T-PRESS CW
A=B PRESS
A/B PRESS
KEYER PRESS
CLAR PRESS
FAST PRESS
LOCK PRESS
SHIFT PRESS
DSP/SEL TURN
PRESS
MAIN DIAL TURN
STATE FUNCTION
Toggle system ON/OFF
- Step DSP contour, notch, digital noise reduc, width, OFF
- Step through combinations of ATT and IPO off and on
Voice tone to compare with CW tone to spot the frequency
- Toggles noise blanker
- Step automatic gain control through auto, fast, slow
Turn off automatic gain control
- Steps forward through enabled bands
menu Steps forward through bands to enable/disable
- Steps backward through enabled bands
menu Steps backward through bands to enable/disable
- Toggle enable/disable of automatic antenna tuner
Start tuning to antenna process
- Enter the "F■" (function) state
menu Generates the next group of 5 practice CW characters
cwtrain
- Enter or leave the "menu" state (see section 6 adaptation)
power off Reset adaptation to factory default when turn power on
- Step through power, ALC, standing wave ratio meter
Start brightness adjustment via DSP/SQL(end with press)
- Steps forward through enabled modes
-menu Steps forward through modes to enable/disable
CW Toggles between USB and LSB reception
power off Display software version (194) when turn power on
- Steps forward through enabled modes
-menu Steps backward through modes to enable/disable
Toggles between USB and LSB reception
- Copy the current VFO settings into the secondary VFO
- Swap the current and secondary VFO settings
- Toggle CW keyer on/off (manual vs space assisted keying)
- Allow offset of receive frequency with "MAIN" dial
- Toggle increase in frequency steps for both dials
- Lock frequency (see details) to avoid accidental change
- Shift the intermediate frequency (IF) pass band
- Small kHz steps in frequency (see Table 5)
100 KHx steps in frequency (may be adapted to set CW
side tone, CW speed, 1 mHz steps, mic gain, or rf power)
MEMORY single channel steps
single groups steps
DSP Step values for selected filter (shown by ">")
MENU Step through list of adaptable items
MENU Step through allowed values fore individual items
blink
- Toggle between small and large steps in frequency
MEMORY Toggle between groups and individual memory numbers
DSP Toggle type of filter on/off, sense, magnitude (see writeup)
MENU select menu item (blink menu display) for setting
- Fine setting of frequency (end memory mode)
- 2 -