Ssb Setup - Yaesu FT-450 User Manual

YAESU HF/50 mHz Transceiver FT-450 User's Manual
1) Set theshift, ATT, IPO, RF gain and AF gain as shown in section 8,
2) Select the band,
3) Set the mode as CW,
4) turn the keyer on,
5) Turn BK-IN on,
6) Set the DSP parameters the way you think you want them, and
7) Select a good starting frequency.
8) Save this setting in the channel memory and remember where you put it.
You are now ready to go. Either dial in the frequency you want to initiate communications or
dial to look for someone calling.
Then next time you want to start up on the same band:
1) Set theshift, ATT, IPO, RF gain and AF gain as shown in section 8,
2) Restore the memory channel for this setting
If you plan to change frequency, nudge the MAIN dial to enter M_TUNE. Either dial in the
frequency you want to initiate communications or dial to look for someone calling.
8.2

SSB Setup

The first time, for straightforward communication:
1) Set theshift, ATT, IPO, RF gain and AF gain as shown in section 8,
2) Select the band,
3) Set the mode to USB above 10 mHz or LSB below 10 mHz,
4) turn the VOX on,
7) Set the DSP parameters the way you think you want them, and
8) Select a good starting frequency.
- 26 -