Table of Contents
Advertisement
When replacing the fuel cap, insert
the tether in its hole before
tightening the cap. Turn the fuel cap
clockwise until it clicks. It will require
more effort to turn the fuel cap on
the last turn as you tighten it. Make
sure the cap is fully installed. The
diagnostic system can determine if
the fuel cap has been left off or
improperly installed. This would
allow fuel to evaporate into the
atmosphere. See Malfunction
Indicator Lamp on page 5-15.
If the vehicle has a Driver
Information Centre (DIC), the
TIGHTEN GAS CAP message
displays if the fuel cap is not
properly installed.
Warning
If a fire starts while you are
refuelling, do not remove the
nozzle. Shut off the flow of fuel by
shutting off the pump or by
notifying the station attendant.
Leave the area immediately.
Notice: If you need a new fuel
cap, be sure to get the right type.
Your dealer can get one for you.
If you get the wrong type, it may
not fit properly. This may cause
the malfunction indicator lamp to
light and may damage the fuel
tank and emissions system. See
Malfunction Indicator Lamp on
page 5-15.
Filling a Portable Fuel
Container
Warning
Filling a portable fuel container
while it is in the vehicle can cause
fuel vapours that can ignite either
by static electricity or other
means. You or others could be
badly burned and the vehicle
could be damaged. Always:
Use approved fuel
containers.
Driving and Operating
Warning (Continued)
Remove the container from
the vehicle, boot, or pickup
bed before filling.
Place the container on the
ground.
Place the nozzle inside the fill
opening of the container
before dispensing fuel, and
keep it in contact with the fill
opening until filling is
complete.
Fill the container no more
than 95% full to allow for
expansion.
Do not smoke, light matches,
or use lighters while
pumping fuel.
Avoid using mobile phones or
other electronic devices.
(Continued)
9-47
Advertisement
Chapters
Table of Contents
