Hazard Lights; Turn And Lane-Change; Signals - Cadillac 2014 Escalade ESV Owner's Manual

6-4 Lighting
not operating, these lamps turn off.
Move the exterior lamp control to
or to disable this feature.

Hazard Lights

(Hazard Warning Indicators):
Press this button to make the front
and rear indicator lamps flash on
and off. Press again to turn the
flashers off.
When the hazard warning indicators
are on, the vehicle's indicators will
not work.

Turn and Lane-Change

Signals

Move the indicator stalk all the way
up or down to signal a turn.
An arrow on the instrument cluster
flashes in the direction of the turn or
lane change.
Raise or lower the stalk for less than
one second until the arrow starts to
flash to signal a lane change. This
causes the indicators to
automatically flash three times.
It will flash six times if tow-haul
mode is active. Holding the indicator
stalk for more than one second will
cause the indicators to flash until
you release the stalk.
The stalk returns to its starting
position whenever it is released.
If after signalling a turn or a lane
change the arrows flash rapidly or
do not come on, a signal bulb may
have burned out.
Have any burned out bulbs
replaced. If a bulb is not burned out,
check the fuse. See Fuses and
Circuit Breakers on page 10-33.
Indicator On Chime
If the indicator is left on for more
than 1.2 km (0.75 mi), a chime will
sound at each flash of the indicator
and the message INDICATOR ON
will also appear in the Driver
Information Control (DIC). To turn
the chime and message off, move
the indicator stalk to the off position.