Connecting The Camera To A Router Not Supporting Upnp - Panasonic BL-C30 Installation/Troubleshooting Manual

1.5 Connecting the Camera to a Router Not
Supporting UPnP™
To allow access from the Internet with a router not supporting UPnP
procedures below.
1.
Select [Static] on the Network page.
(1) Access the camera (see page 8 of the Operating Instructions on the
Setup CD-ROM).
(2) Click [Setup] tab at the top of the page.
(3) Select [Static] on the Network page.
•
(4) Click [Save] without changing the settings.
(5) Click [Restart].
2.
Enable port forwarding on the router.
Using the IP address and port number note written on step 1-(3), enable port
forwarding on the router. See the router manual for how to enable port
forwarding.
3.
Register with the Viewnetcam.com service.
Port Forwarding feature
The port forwarding feature is required to allow access from the Internet with a
router not supporting UPnP
Each camera must be assigned a unique port number.
Global IP address
of the router
vvv.xxx.yyy.zzz:80
vvv.xxx.yyy.zzz:81
Internet
"Port forwarding" may be called "Address translation", "Static IP Masquerade", "Virtual server"
*1
or "Port mapping" in other products.
The Static IP Address Configuration page is displayed. Make a
note of the IP address and port number, since they are required to
enable port forwarding on the router.
*1
. It exchanges a private IP address to a global one.
TM
Port Forwarding feature
Port No.
Modem
CATV
192.168.0.1
xDSL
Optical cable
Private IP address
vvv.xxx.yyy.zzz:80
vvv.xxx.yyy.zzz:81
Router
Installation/Troubleshooting
192.168.0.253:80
192.168.0.252:81
192.168.0.252 192.168.0.253
Port No. 80
Port No. 81
, follow the
TM
13