Connecting The Camera To A Router That Supports Upnp ™ (Ipv4 Only); Connecting The Camera To A Router That Does Not Support Upnp ™ (Ipv4 Only) - Panasonic BB-HCM403A Operating Instructions Manual

4.
Click [Go to UPnP page].
• The UPnP page is displayed.
2.7.1 Connecting the Camera to a Router that Supports
UPnP
To allow access from the Internet with a router supporting UPnP
procedures shown in Getting Started.
Note
• On some routers, the UPnP
router's UPnP
camera. See the Panasonic Network Camera support website at
http://panasonic.co.jp/pcc/products/en/netwkcam/ for details.
• If a maximum idle time is set in PPPoE or PPTP connection with your ISP,
disable it on the router. See the router manual for details.
2.7.2 Connecting the Camera to a Router that Does Not
Support UPnP
To allow access from the Internet with a router that does not support UPnP
the procedures below.
1.
Select [Static] on the Network (IPv4) page.
(1) Access the camera (see page 11).
(2) Click the [Setup] tab at the top of the page.
(3) Select [Static] on the Network page.
•
Note
(4) Click [Save] without changing the settings.
(5) Click [Restart].
2.
Enable port forwarding*
Using the IP address and port number noted on step 1-(3), enable port
forwarding on the router. See the router manual for how to enable port
forwarding.
3.
Register with the Viewnetcam.com service.
™
(IPv4 Only)
™
feature following the router manual before you set up the
™
The Static IP Address Configuration page is displayed. Make a
note of the IP address and port number, since they are required to
enable port forwarding on the router.
• You must assign a unique IP address and a unique port number
to each camera on the LAN.
1
on the router.
™
feature is disabled by default. Enable your
(IPv4 Only)
Operating Instructions
™
, follow the
™
, follow
58