Information You Will Need About Your Lan Or Computer - D-Link DSL-504T Manual

DSL-504T User's Manual

Information you will need about your LAN or computer

Ethernet NIC
DHCP Client
status
It is recommended that your collect and record this information here, or in some other
secure place, in case you have to re-configure your ADSL connection in the future.
Once you have the above information, you are ready to setup and configure your
DSL-504T ADSL Router.
D-Link Systems, Inc.
If your computer has an Ethernet NIC, you can connect the
DSL-504T to this Ethernet port using an Ethernet cable. You can
also use the Ethernet port on the DSL-504T to connect to other
Ethernet devices, such as a Wireless Access Point.
Your DSL-504T ADSL Modem is configured, by default, to be a
DHCP server. This means that it can assign an IP address, subnet
mask, and a default gateway address to computers on your LAN.
The default range of IP addresses the DSL-504T will assign are
from 192.168.1.2 to 192.168.1.254. Your computer (or computers)
needs to be configured to Obtain an IP address automatically
(that is, they need to be configured as DHCP clients.)
The Modem may be reset to its factory default settings by performing a
Restore settings operation within the management interface (see System
Commands). If you cannot gain access to the management interface, you
may opt to use the Reset button on the rear panel of the device).
10