Running Program - Dell 1707FPc Service Manual

12.3 Running program

After the installation, a short-cut icon
program.
(1). Select the IC type
Note: Firstly, you can check the I²C normal or not by inputting the "test" in the position
where to load MCU software. Click
(2). Select Options → Connection Setup F10:
will appear on your desktop, double click it will run the
(NOTE: If there is not this selection, please check the "ChipDB"):
, if you can see "test pass" in the blank, the I²C is OK!
65
Dell 1707FPc
,