Getting Started; Hardware Setup - D-Link ShareCenter DNS-320 User Manual

Section 2 - Getting Started
This User Guide will help you get your ShareCenter set up in just a few steps. To install the ShareCenter on your local network,
refer to the steps below, or skip to page 16 to run the setup wizard which will show you how to install and configure your
DNS-320.
Step 1 - Remove the top panel by firmly
pressing the latch at the back.
Note: Make sure to align the drive connector to the SATA connector at the back edge inside the drive bay of the ShareCenter.
Gently push the drive in until it connects. When a drive is inserted properly, you will feel it "set" into the connector. Some hard
drives that are thin or oddly shaped may need to be inserted carefully into position. If a drive is not properly set in place, the
hard drive LED will not illuminate after powering on the device.
D-Link ShareCenter DNS-320 User Manual

Getting Started

Hardware Setup

Step 2 - Once the faceplate is unlatched,
pull it off the the device to expose the
devices's bays.
11