System Setup; Booting - Inter-m DSR-430 Operation Manual

System Setup

System Setup
NTSC or PAL Type is released; Language can be changed in set-up of menu.
- Under SET key is pressed, power up ; the system is operated as PAL.
- Under SET key is pressed, power up ; the system is operated as NTSC.

1. BOOTING

In the back side, connect with input/output and a mouse and than power up. It makes a booting as below [picture 1-1]
'Found Hard-Disk...' message is disappeared, the system booting was concluded normally.
If you do not find a hard disk, 'No Hard-Disk found' message is shown. A damage of a hard disk, poor
connections of HDD or use of low level of electronic power adaptor are also shown like that.
The date, time, availability of hard disk is shown in the downward of screen.
To set up a product the first time, format HDD with reference to 'Hard-Disk' part of manual. [3-6 Hard Disk]
A mouse and keypad can not be used simultaneously.
(exclusive of SET[Record] /
When you power up without mouse connection, equipments can be controlled by remote control and key pad.
When you put the power ON only with the mouse connected, equipments can be controlled by only mouse.
(SESESET[Record Start] and
[picture 1-1]
ESC[STOP])
ESC [Record Stop] of Keypad is operated.)
STAND ALONE DVR
11
DSR-430