Table of Contents
Advertisement
2.
Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
P5N73-AM Digital Audio Connector
The S/PDIF module is purchased separately.
3.
IDE connector (40-1 pin PRI_IDE)
The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable. There are
three connectors on an Ultra DMA 133/100/66 signal cable: blue, black, and gray.
Connect the blue connector to the motherboard's IDE connector, then select one of the
following modes to configure your device.
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
P5N73-AM
1-20
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
cable connector. This prevents incorrect insertion when you connect the IDE cable.
IDE Connector
SPDIF_OUT
Mode of device(s)
-
Master
Slave
Master
Slave
Chapter 1: Product introduction
Cable connector
Black
Black
Gray
Black or gray
If any device jumper is set as
"Cable-Select," ensure that
all other device jumpers have
the same setting.
Advertisement
Table of Contents
