Advertisement
If your vehicle has carpet covering the floor, cut the carpet so that the Floor Mounting Brackets are installed flush on the metal floor. If the Floor Mounting
WARNING
Brackets are not flush mounted, the seatback may not lock in place, which could result in serious injury to you and others.
1985 and Older Vehicles
Step One
Floor Mounting Bracket Installation
Orient the Seat, with the Legs on the bottom of the seat facing the rear of
the vehicle. Fold the Seat back down into the closed position.
Attach the two (2) Floor Mounting Brackets to the bottom of the seat by
sliding the pins of the Floor Mounting Brackets into the holes of the
brackets on the bottom of the seat. Install Cotter Pins through the small
hole in the Floor Mounting Bracket pin of the left and right Floor
Mounting Brackets. The loop on the Floor Mounting Bracket is to face the
front of the vehicle.
Set the Seat in the rear of the vehicle. Open the Seat, and with the seat
back in the raised position center the Seat from side to side and in the
desired position from front to rear.
Once the Seat is in the desired position lower the seat back and "tumble"
the Seat forward, maintaining the Floor Mounting Brackets in position.
Using the Floor Mounting Brackets as templates, mark hole locations of
the Floor Mounting Brackets. Remove the seat. Center punch and drill a
25/64" hole at each mark. Remove the Floor Mounting Brackets from the
seat.
Align the Floor Mounting Brackets over the drilled holes with the loops
on the Mounting Bracket positioned toward the front of the vehicle. From
underneath the vehicle, align the tapping plates and M8-1.25 Hex Nuts
over the drilled holes and hold them in place. Insert two (2) M8-1.25 x
35mm Bolts with two (2) Flat Washers through each Mounting Bracket.
Loosely tighten the bolts using an adjustable wrench or 10mm wrench.
39333/39343 pg 4
Cotter Pin
Floor Mounting
Brackets
Rear of Vehicle
Tapping Plate -
under floor
M8-1.25 Hex Nuts -
under floor
Seat
Slide Brackets on
Seat over Pins on
Floor Mounting
Brackets
Floor Mounting
Bracket
M8-1.25 x 35mm Bolts
Front
Loop toward
front
Flat Washers
Floor Mounting
Bracket
1201 Rev. B
Advertisement
