Setup And Operation - Keurig B30 Use And Care Manual

SECTION 1
SET-UP & OPERATION
Plug Brewer into its own grounded outlet.
If the electric circuit is overloaded with other
appliances, your Brewer may not function
properly. If possible, the Brewer should be
operated on its own circuit, separate from
other appliances.
CAUTION: There are two sharp needles
that puncture the K-Cup
one above the K-Cup
other in the bottom of the K-Cup
To avoid risk of injury, do not put your
fingers in the K-Cup
Select a K-Cup ® portion pack. Do not remove
the foil lid or puncture the K-Cup
1
2
3
2
® portion pack,
® Holder and the
® Holder.
® Chamber.
® portion pack.
Make sure the brew-
er is plugged in.
Press the Power
Button found on the
front of the Brewer.
Depress the large
"PRESS TO OPEN"
button on top of the
brewer.
Place a K-Cup ®
portion pack in the
K-Cup ® Holder.
Do not remove
the foil lid.
4
5
6
NOTE: Do not use a clear, glass mug.
Cup sensor will not "read" the glass mug
and the "Place Mug" light will flash.
7
Your cup of gourmet coffee, tea or hot cocoa
will be ready in less than 3 minutes. Enjoy!
Lower the Handle
completely and
firmly to close the
Lid and puncture the
K-Cup ® portion pack.
The Hot Water Tank
cover will open auto-
matically.
Fill the Hot Water
Tank with filtered or
bottled water up to
the FILL LEVEL
indicator.
Close the Hot Water
Tank cover. The
"PLACE CUP" light
will be flashing
Place a 10 oz coffee
cup in the dispense
area on the drip tray.
Press the flashing
BREW button. The
HEATING light will be
illuminated.
When the water
reaches temperature,
the HEATING light
will go off and the
coffee/tea/hot cocoa
will start to dispense.