Advertisement
Maintenance
1.
If motors or blowers need servicing, or oiling they can
easily be removed removing screws as illustrated in
Figure 2. The complete assembly then slides out, after
electrical plug connector is unplugged.
2.
If heat sections need servicing, they can easily be
removed by removing screws ("A") in Figure 2. The
complete heat section assembly then slides out, after all
wires into the terminal block are removed. Care must be
taken to assure that all wires are replaced in the correct
terminal block as per wire numbering or coding. The limit
control and elements can be readily serviced when the
heat section is removed.
3.
All controls are readily accessible through the inner
control door. All controls can be serviced through this
door.
4.
Filter is accessible after the front panel is opened. Slide
filter out and clean or replace a minimum of twice per
heating season. Optional permanent type filter can be
cleaned with water and detergent or any available filter
cleaning solution.
Figure 9
NOTE:
OUTLET
ALTERNATE LOCATION
OF DUCT COLLAR WHEN
CONTROL SECTION
LOCATED AT FRONT
INLET
FRONT PANEL
NOTE:
ALTERNATE LOCATION OF DUCT
COLLAR WHEN LOCATED AT FRONT
1367 Industrial Road
Cambridge ON Canada N1R 7G8
1-888-346-7539
www.dimplex.com
In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.
© 2011 Dimplex North America Limited
3
AREA
CABINET SIZE
DUCT OPENING
SQ. FT. (METER)
32" (813)
4" (102) x 15" (381)
.41 (.039)
45" (1143)
4" (102) x 28" (711)
.78 (.072)
65" (1651)
4" (102) X 49" (1245)
1.37 (.127)
78" (1982)
4" (102) X 61 1/4" (1156)
1.70 (.158)
Warranty
The Manufacturer warrants the heater and components of the enclosed product
against any defect in material or workmanship for a period of one year from
the date of purchase. In full satisfaction of any claims under this Warranty the
Manufacturer will repair or replace without charge, in its factory or in the field as it
alone may decide, any parts which in its opinion are defective.
The Manufacturer shall not be responsible for any transportation or shipping
costs in relation to such repair or replacement except as specifically assumed
by it. Misuse of this product or repairs by persons other than the Manufacturer's
authorized personnel without the Manufacturer's written approval, will void this
Warranty.
This Warranty is in lieu of all other warranties or conditions whether expressed or
implied including but not limited to those of merchantability or fitness for purpose
and shall constitute the sole remedy of the Purchaser and the sole liability of the
Manufacturer in respect of the sale of the product, whether in the nature of breach
or breach of fundamental term, or of negligence or otherwise.
The Manufacturer shall not be liable for any special, indirect or consequential
damages or for any damages resulting from removal or replacement of the heater
subject to warranty claim without the Manufacturer's authorization.
This Warranty is transferable by the original consumer purchaser of the product.
Any claims under this Warranty must be submitted in writing to the Service
Manager, Dimplex North America Ltd., 1367 Industrial Rd., Cambridge, Ontario
N1R 7G8, Canada.
Replacement Parts
Motor 1/10HP 208/240V 1PH
1/20HP 208/240V 1PH
1/30HP 208/240V 1PH
1/20HP 208V 1PH
1/20HP 240V 1PH
1/30HP 277V 1PH
Capacitor
Element
208V
1000w
240V
1000w
277V
1000w
347V
1000w
480V
1000w
600V
1000w
Contactor
40A
208/240v
50A 208/240v
Cutout
Blower housing
Blower wheel
Thermostat
Thermostat knob
Hi/Low switch
On/Off switch
Relay
Part No.
08071101RP
02024293RP
02024101RP
02024288RP
02024290RP
02024102RP
02007005RP
02030057RP
2000w
02030054RP
02030058RP
2000w
02030055RP
02030059RP
2000w
02030056RP
02050036RP
2000w
02050037RP
02032073RP
2000w
02032072RP
02050038RP
2000w
02050039RP
2400160300RP
277v
2400160400RP
2400160900RP
02005317RP
30006858RP
02000083RP
03005036RP
8800030200RP
2800060100RP
02005038RP
02005592RP
Part No.
Advertisement
