Advertisement
Operation
WARNING: This heater must be properly installed before it
is used.
CONTROLS
•
Fan Delay - The heater is equipped with a fan delay con-
trol. There will be a short delay to enable the heating ele-
ments to warm up before the fan turns on. The fan will
also remain on for a few moments after the elements are
de-energized.
•
Automatic High Limit - Each heater is equipped with au-
tomatic reset thermal cutouts. Should these safety switch-
es operate, they will automatically reset once the element
reaches a safe operation temperature, however, the cause
of the high limit condition should be determined and cor-
rected to sure satisfactory operation.
OPTIONAL CONTROLS
•
Integral thermostats - All units are available with a built-in
snap-action thermostat. The sensing element is located
in the return air stream to provide accurate temperature
control. The thermostat has a range of 40°F (5°C) (low) to
100°F (38°C) (high). It can be manually operated or ren-
dered tamper-proof as desired. This control can be field-
mounted or factory mounted.
•
Remote Line Voltage Thermostat - All units can be con-
nected to a line-voltage remote thermostat. A special con-
trol terminal block is provided in all units to facilitate easy
connection of the remote thermostat control wiring.
•
Remote Low Voltage Thermostat with Relay - A low volt-
age transformer/relay can be field or factory installed with
the unit for remote low voltage thermostatic control. The
special control terminal block is utilized for this optional
control feature.
•
Fan-Only Switch - An optional fan-only switch is available
for integral mounting within the unit. This switch provides
continuous fan-operation, independent of the built-in or
optional remote thermostatic control, which is effective in
eliminating air stratification.
START UP
1.
Before the unit is energized, the discharge louvres should
be adjusted for desired air deflection.
2.
Check to see that all controls and optional accessories are
operation properly.
Maintenance
CAUTION: Before removing the front cover for cleaning,
make certain the power has been turned off at the circuit
breaker panel.
CAUTION: Allow adequate time for the element and body
casing to cool before attempting to work on the heater.
1.
Under normal conditions, the heater should be cleaned
once a year. DISCONNECT ALL POWER before cleaning
or servicing the heater.
2.
All motors are lubricated for extended life operation, and
will not have to be oiled.
1367 Industrial Road
Cambridge ON Canada N1R 7G8
1-888-346-7539
www.dimplex.com
In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.
© 2014 Dimplex North America Limited
Warranty
The Manufacturer warrants the heating elements and components of the enclosed
product against any defect in material or workmanship for a period of one year
from the date of purchase. In full satisfaction of any claims under this Warranty the
Manufacturer will repair or replace without charge, in its factory or in the field as it
alone may decide, any parts which in its opinion are defective.
The Manufacturer shall not be responsible for any transportation or shipping costs in
relation to such repair or replacement except as specifically assumed by it. Misuse
of this product or repairs by persons other than the Manufacturer's authorized
personnel without the Manufacturer's written approval, will void this Warranty.
This Warranty is in lieu of all other warranties or conditions whether express or
implied including but not limited to those of merchantability or fitness for purpose
and shall constitute the sole remedy of the Purchaser and the sole liability of the
Manufacturer in respect of the sale of the product, whether in the nature of breach
or breach of fundamental term, or of negligence or otherwise.
The Manufacturer shall not be liable for any special, indirect or consequential
damages or for any damages resulting from removal or replacement of a heater
subject to warranty claim without the Manufacturer's authorization.
This Warranty is transferable by the original consumer purchaser of the product.
Any claims under this Warranty must be submitted in writing to the Service Manager,
Dimplex North America Ltd., 1367 Industrial Rd., Cambridge, Ontario N1R 7G8,
Canada.
Replacement Parts
Thermostat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 03005043RP
Control Knob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 02028016RP
Control Fuse . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 04005103RP
Terminal Block . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4000040600RP
Grille . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30006159-SARP
15-25kW
Fan Blade
02000017RP
Motor
2000080200RP
Casing
30006730-SARP
Louver
30000013-SARP
Hi Limit
Cutout
Fan Delay
Relay
Capacitor
00857007RP
2400160300RP
Contactor
2400161300RP (above 48A)
347V: 2100080022RP
Transformer
480V: 2100080011RP
600V: 2100080012RP
15kW: 2200270100RP
208V
20kW: 2200270500RP
Elements
25kW: 2200270800RP
15kW: 2200270200RP
240V
20kW: 2200270100RP
Elements
25kW: 2200270900RP
347V
15kW: 2200271400RP
Elements
20kW: 2200271600RP
15kW: 2200270300RP
480V
20kW: 2200270600RP
Elements
25kW: 2200271000RP
15kW: 2200270400RP
600V
20kW: 2200270700RP
Elements
25kW: 2200271100RP
*All units have 6 elements unless otherwise indicated
30kW
02000018RP
2000090100RP
03005039RP
06942602RP
02007005RP
2200271800RP
N/A
N/A
2200271200RP
2200271300RP
40-50kW
02000045RP
3024019RP
30006851-SARP
30006855-SARP
03005046RP
03005044RP
N/A
2400160200RP
480V: 02005869RP
600V: 03005045RP
N/A
N/A
N/A
40kW: 02038336RP
(9 elements/unit)
60kW: 02038338RP
(9 elements/unit)
40kW: 02038337RP
(9 elements/unit)
60kW: 02038338RP
(9 elements/unit)
Advertisement
