Wand Assembly - Echo MS-41BP Use And Care Manual

SPRAYER COMPONENTS & USE INFORMATION, Continued

WAND ASSEMBLY

1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining Nut
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump
shaft (A). To install the pump handle place the handle (C)
over the shaft (A) aligning the pump handle hole and shaft
hole. Slide the bolt (B) through the aligned hole as shown in
figure 1 thru 4. Tighten nut (D) to bolt. There are holes in the
pump handle to allow for either left(fig.4) or right (fig.5) hand
mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt
Pump Handle
Positioned For Use
(right hand shown)
O-ring
Wand
Figure 2
Line up holes
Figure 5
Left Hand
3E
Shut-off
Valve
A
B
D
C
Figure 3
Slide bolt through holes
Figure 6
Right Hand