Equinox Systems SuperSerial Product Installation Manual page 11

2.4.3 Creating and Using OpenServer ESP Installation Diskettes
on DOS
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
2. Set your default drive to the CD-ROM drive letter.
3. Run the command
product and operating system for which diskettes are needed.
4. Once the OpenServer installation diskette is created, refer to
the following le for detailed installation instructions:
/drivers/esp/sco/readme.txt
2.4.4 Creating and Using OpenServer ESP Installation Diskettes
on Microsoft Windows
1. Load the Equinox SuperSerial Software CD into your CD-ROM drive.
• If you have autoplay enabled, the Equinox SuperSerial Software
Installation screen will appear.
• If you do not have autoplay enabled, set your default drive to
D: and run the command
drive letter.
2. Click UNIX on the Main Window.
3. Select the UNIX operating system for which you need drivers. Follow
the on-screen instructions for creating an installation diskette.
4. Once the OpenServer installation diskette is created, refer to
the following le for detailed installation instructions:
/drivers/esp/sco/readme.txt
11
Equinox ESP 10/100 Serial Hub Product Installation Guide
and select the appropriate Equinox
MAKEUNIX
D:\SETUP,
where D: is your CD-ROM