Hardware Overview; Connectors And Buttons - Axis P3346 User Manual

AXIS P3346 Fixed Dome Network Camera

Hardware Overview

Hardware Overview
1
Product ID and Serial number (S/N)
2
SD card slot
3
Network connector (PoE)
4
Audio out
5
Network, Status and Power LED indicators
6 Audio in
7
I/O connector
8 Control button

Connectors and Buttons

For technical specifications, see page 59.
Network Connector
RJ45 Ethernet connector. Supports Power over Ethernet (PoE).
NOTICE TICE
NO NO TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network switch
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. For
information about regulatory requirements, see Regulatory Information on page 2 .
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, time lapse recording
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for example:
PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes
active (shown under System Options > Ports & Devices).
1
3
4
7
6
5
6
8