Table of Contents
Advertisement
7.
After all of the settings are configured the way you
want, press the A
A
A
A button.
A
• This exits the setting screen.
• The watch also will exit the setting screen automatically if you
do not perform any operation for about two or three minutes.
Digital-Analog Synchronization
The watch automatically adjusts its analog setting to match the
current digital time setting.
• When adjusting the analog time, the watch always moves the
hands forward (clockwise direction).
• Depending on how different the digital and analog time settings
are, it may take some time for the analog hand setting procedure
to be finished.
Operation Guide 3334
Manually Setting the Analog Time
You can use the Hand Setting Mode to manually adjust the analog
time when it does not match the digital time.
1.
Use the C
C button to enter the Hand Setting Mode.
C
C
C
2.
A
A
Hold down A
A
A for about
one second until the time
digits start to flash in the
bottom dial. This is the
setting screen.
3.
Use the D
D button to
D
D
D
adjust the analog time.
• Each press of the D button
advances the analog time by
20 seconds.
• Holding down the D button
advances the analog time at
high speed.
High-speed Lock
• While holding down the D button (which advances the analog
time at high speed), press the B button to lock high-speed
advance of the analog time.
• High-speed analog time advance will continue until it completes a
12-hour cycle, or until you press any button to stop it.
4.
After the setting is the way you want, press the A
button.
• This exits the setting screen and automatically synchronizes
the minute hand with the current seconds count.
• The watch will also exit the setting screen automatically if you
do not perform any operation for about two or three minutes.
(Forward)
A
A
A
A
8
Advertisement
Table of Contents
