Bearings; Left And Right Weight - AEG Electrolux EMW2000 Service Manual

14)

Bearings

a) Disassembling/Assembling
Left bearing
During assembling take care to the correct position of the round gasket. Clean the
drum shaft, grease the shaft-sealing ring, screw the bearing to the tub (closed
sense). Screw in the drum screw with pulley.
Right bearing
During assembling take care to the correct position of the round gasket. Clean the
drum shaft, grease the shaft-sealing ring, screw the bearing to the tub (closed
sense). Slip on and screw the pulley.
Note: These bearings are auto-fastening, therefore do not fasten them too strong.
15)

Left and right weight

a) Disassembling / Assembling
The whole tub can be equipped with 3 kinds of weights:
-
-
-
Right weight
1
2
3
HV844-N 12.01 R.B.
weight of concrete
weight with a "polypropylene" housing
weight of iron
- Remove the right side panel.
- Remove the foam damper.
- Untighten and remove the 4 screws for the fixation of the weight, which
have a different length depending on the kind of weight.
1 -
2 -
3 -
1 - Remove the right side panel.
2 - Remove the drum screw with pulley.
3 - Remove the pulley.
4 - Remove the earth connection of the
drum.
5 - Loosen the bearing (open sense)
with a spanner
ET-no. 8992980018-48/5.
- 21 -
Remove the left side panel.
Remove the drum screw.
Loosen the bearing (open sense)
with a spanner as shown in the
figure, ET-no. 899 2980018-48/5
599 51 30 44 EN