Lifesaver jerrycan Instruction Manual page 12

CAUTION
Changing your LIFESAVER
cartridge in the field causes
a heightened risk of cross
contamination during cartridge
change over. Should you need
to replace your cartridge, ensure
you have clean, dry hands. Once
the expired cartridge is removed,
clean, disinfect and dry the
jerrycan before inserting the new
cartridge. This will reduce the
risk of cross contamination.
1
2
3
12
How to install a new LIFESAVER
jerrycan UF cartridge
Before changing your cartridge, try front-
®
side washing first to remove particulate
matter (page 10). This may just extend the
life of your cartridge long enough to meet
your requirements.
As the LIFESAVER
designed for exceptional service life, it
is rare that you will need to change the
cartridge whilst in the field. However,
should it be necessary, it is very important
that you follow these instructions carefully:
• Empty the jerrycan of water.
• Unscrew & remove tap cap and tap.
• Remove the old cartridge
discard it responsibly.
• Thoroughly clean the LIFESAVER
jerrycan and pump by washing it with
mild washing up liquid in warm water
(use a soft cloth for this). Ensure that
all dirt is removed and the jerrycan is
thoroughly clean. Rinse thoroughly and
allow to dry.
• Remove the new LIFESAVER
UF cartridge from it's packaging.
• Insert the new cartridge into the jerrycan.
• Insert the tap into the tap cap
thread onto the jerrycan.
the tap cap is tightened firmly.
• You now need to prime the cartridge.
(See page 6 for priming)
Your LIFESAVER
to use again.
jerrycan has been
®
3
jerrycan is now ready
®
If you are having problems
changing your cartridge, just
ring the LIFESAVER
®
+44(0)1206 580999
®
and
1
®
jerrycan
®
and
2
Ensure that
Team on