Install Chute Control - Ariens Pro 28 Quick Start Manual

Step Three: Install Chute Control
1. Remove the rubber grommet from the dash by pinching the
long-edged sides together and pulling upward. Set aside for
reinstallation.
2. Remove and save the hairpin from the control assembly.
3. Route the chute control assembly underneath the crossbar of
the lower handlebar. Install the handle of the chute control
assembly through the underside of the slot opening in the dash.
Insert the chute control assembly into the mounting bracket that
is welded to the underside of the dash. Make sure the poly liner
bushing is properly seated into the mounting bracket. The
handle should angle towards the engine.
4. Reinstall the rubber grommet into the dash.
Assembly