Osd Aging Mode & Lock/Unlock - Philips 170C4FS/00 Service Manual

Front control panel
Fig. 1
To Lock/Unlock OSD function (User Mode)
The OSD function can be locked by pressing "OK" button(1) for more
than 10 seconds, the screen shows following windows for 3 seconds.
Everytime when you press "AUTO" or "OK" button, this message
appears on the screen automatically.
ATTENTION
OSD MAIN CONTROLS LOCKED
Unlock OSD function:
Locked OSD function can be released by pressing"OK" button for
more than 10 seconds again.
ATTENTION
OSD MAIN CONTROLS UNLOCKED
To Enable/Disable "Warning message" on screen
(in User Mode)
Step 1: Turn on LCD monitor, and disconnect Interface Cable
between Monitor and PC.
Step 2 :
Push AUTO " " button for more than 10 seconds to disable
"warning message", bring up
ATTENTION
ATTENTION SIGNAL OFF
Step 3 :
Push AUTO " " button for more than 10 seconds again to enable
"warning message", bring up
ATTENTION
ATTENTION SIGNAL ON
Status 1.: Turn off monitor, then turn on monitor again
=> go back to last display.
Status 2. Connect signal cable again
=> go back to Windows screen.
OSD Lock/Unlock, Aging & ,
Enable/Disable "warning message"
Fig. 2
Fig. 3
Access Aging.. Mode
Step 1: Turn off LCD monitor, and disconnect Interface Cable
between Monitor and PC.
Step 2 :
[Push AUTO " " & OK "
it ] + [Press power " " button untill comes out "AGING screen"
] => then release all buttons.
:
Bring up
A G I N G ... A G I N G ...
After 15 seconds, bring up :
After 15 seconds, bring up :
A G I N G ... A G I N G ...
After 15 seconds, bring up :
----------
----------
repeatly
Connect signal cable again => go back to normal display.
170C4/N4
Go to cover page
" buttons at the same time and hold
7