Quick Start; Selecting A Kit; Playing The Pads; English - ION Redline User Manual

User Guide (English)
Support
For complete system
ionaudio.com/redline-drums.
For additional product support, visit ionaudio.com/support.

Quick Start

Connecting the Drum Module
Connect the cable snake here (using the two
screws to secure it), and then connect the 1/4"
ends of the cables to their respective pads.

Selecting a Kit

To select one of the module's 10 preset Kits, do one of
the following:
• Press the Variation Button so it is lit red, and then
press the 1, 2, 3, 4, or 5 Button to select Kit 1, 2,
3, 4, or 5 (respectively).
• Press the Variation Button so it is lit green, and then press the 1, 2, 3, 4, or 5 Button to select Kit 6, 7,
8, 9, or 10 (respectively).
The Kit number will appear in the display. Once you have selected a Kit, you can select others by repeating
one of the steps above or by using the – and + Buttons.

Playing the Pads

If your electronic drum kit has velocity-sensitive pads, this drum module will play sounds of varying timbres
depending on how hard you hit the pads. Try hitting the pads with different amounts of force to experiment
with the different sounds produced by the module!
Note: The hi-hat sound will vary based on the position of the hi-hat controller pedal:
•
Open hi-hat: With your foot off of the pedal, hit the hi-hat pad.
•
Closed hi-hat: With your foot pressing the pedal all the way down, hit the hi-hat pad.
•
Pedal close: Press the hi-hat pedal all the way down without hitting the hi-hat pad.
•
Splash: Quickly press the hi-hat pedal all the way down, and then release it immediately.
Learn more about using the drum module in the Using the Module section of this manual.
requirements, compatibility information, and
1 2
3
product registration,
3 4 5
visit:
VARIATION