Table of Contents
Advertisement
Connecting a PTZ Camera
Setting up a PTZ Camera is simple. The HVR comes preassembled with an internal PTZ adapter. The
cabling may be run up to 4,000 ft using 22 Gauge Twisted Pair.
It is important to understand how the PTZ connects to the HVR. The HVR outputs an RS-232 signal and
converts in to an RS-422/485 signal which is then sent to the PTZ camera.
Attaching the 4-Pin Adapter
1.
Locate the PTZ adapter cable
2.
Connect the wires of the PTZ adapter to the PTZ camera. The yellow
wire should connect to the RX+ on the camera and the orange wire
should connect to the RX-.
3.
Connect the other end of the adapter to the HVR as shown.
4.
Assign the PTZ camera an ID number in PTZ Setup that coincides with
the number assigned to the camera. This is normally done utilizing a
dip-switch configuration method on the addressable dome.
Example If the camera is plugged into input number 5, set the PTZ unit to ID
number 5.
30720AB
Signal Line (+)
Signal Line (-)
31
Advertisement
Table of Contents
