Table of Contents
Advertisement
Looping Outputs
The 8/16 Channel HVR unit may have up to 16 Looping outputs. Depending on the destination of the
outputs, each output may have to be terminated. The outputs are located on the BNC Connector
Cable. Attach the cable to the input for the BNC Connector Cable highlighted below.
The video inputs are 75 Ώ BNC connectors. Make sure there is a video source connected to the input
and then connect a cable to the Channel Out on the BNC Connector Cable. The looping outs can be
connected to video monitors or combined with adapters to connect to VCR's.
Looping Output Termination
When terminating the outputs becomes necessary, the HVR unit has built in termination that allows you
to select individual outputs to terminate individually. It is not always necessary to terminate the output
when using it. It is dependent on the device with which you are connecting it to. As a rule, if the image
appears distorted or virtually unviewable, it most likely needs to be terminated.
Always leave the dipswitch set to the ON position when the Looping Outputs are not used.
30
ON
Not connected to a monitor (Normal)
OFF
Connected to a monitor (Looped)
Advertisement
Table of Contents
