Kenwood DNX Installation Manual page 4

Connection
Connector Function Guide
Pin Numbers for Cable Colour
ISO Connectors
External Power
Connector
A-4 Yellow
A-5 Blue/White
A-6 Orange/White
A-7 Red
A-8 Black
Speaker
Connector
B-1 Purple
B-2 Purple/Black
B-3 Gray
B-4 Gray/Black
B-5 White
B-6 White/Black
B-7 Green
B-8 Green/Black
2WARNING
Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit.
The default connection for the wiring harness is described in
1 below. If the ISO connector pins are set as described in 2,
make the connection as illustrated.
Please be sure to reconnect the cable as shown 2 below to
install this unit to the Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the vehicle's
ISO connector is linked with the ignition, and the A-
4 pin (yellow) is connected to the constant power
supply.
Ignition cable (Red)
Unit
Battery cable (Yellow)
2 The A-7 pin (red) of the vehicle's ISO connector is
connected to the constant power supply, and the
A-4 pin (yellow) is linked to the ignition.
Ignition cable
(Red)
Unit
Battery cable
(Yellow)
4
|
DNX7220
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground)
Connection
Rear Right (+)
Rear Right (–)
Front Right (+)
Front Right (–)
Front Left (+)
Front Left (–)
Rear Left (+)
Rear Left (–)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
Connect to the vehicle's parking brake
detection switch harness using the
supplied relay connector.
Connect to vehicle's reverse lamp harness
when using the optional rear view camera.
To use the steering wheel remote control feature,
you need to an exclusive remote adapter (not
supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal when
using the optional power amplifier, or to the antenna
control terminal in the vehicle.
To "EXT.AMP.CONT. " terminal of the amplifier
having the external amp control function.
PRK SW
For the sake of safety,
be sure to connect the
parking sensor.
To steering remote