Product Identification; Unpacking; Product Features - Desa VSGF36NRC Owner's Operation And Installation Manual

Log Set
Front
Remote Burner
Control
Figure 1 - Log Base Assembly
CAUTION: Do not remove
data plates attached to heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut carton all the way
around above staples on bottom tray. Lift
carton off of heater. Remove packing.
Note: Hood is located on top of fireplace
in a carton.
OPERATION
This vent-free fireplace is clean burning. It re-
quires no outside venting. There is no heat loss
out a vent or up a chimney. Heat is generated
by both realistic flames and glowing embers.
When used without blower, fireplace requires
no electricity making it ideal for emergency
backup heat.
SAFETY DEvICE
This fireplace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff sys-
tem. ODS/pilot is a required feature for vent-
free room heaters. ODS/pilot system shuts off
fireplace if there is not enough fresh air.
121082-01G

PRODUCT IDENTIFICaTION

Rear
Burner
Base
Assembly

UNPaCkING

PRODUCT FEaTURES

www.desatech.com
Top Outer Casing
Top Louver
Assembly
Fireplace
Hood
Screen
Assembly
Bottom Louver Assembly
Figure 2 - Fireplace
2. Locate one screw above top left corner
of fireplace screen. Remove and discard
screw. Lift fireplace screen up and pull out
to remove.
3. Remove protective packaging applied to
logs, log base assembly and fireplace.
4. Check heater for any shipping damage. If
heater is damaged call DESA Heating, LLC
at 1-866-672-6040 for replacement parts
before returning to dealer.
IGNITION SYSTEM
This fireplace has an electronic ignitor to light
heater fuel supply.
REMOTE CONTROL
This fireplace is equipped with a thermostat
remote control. Remote can also be used
manually. Use this remote to control tempera-
ture and flame height.
5