JVC KD-SH1000J Service Manual page 29

QQ
5.5 Signal processing section 3 7 63 1515 0
Is the sound output from
both channels (L, R)?
NO
No sound from either
channel.
NO
Compare the L-ch and
R-ch to locate the
defective point.
5.6 Maintenance of laser pickup
(1) Cleaning the pick up lens
Before you replace the pick up, please try to clean the lens
with a alcohol soaked cotton swab.
(2) Life of the laser diode
When the life of the laser diode has expired, the following
TE
L 13942296513
symptoms will appear.
• The level of RF output (EFM output: amplitude of eye
pattern) will be low.
Is RF output
1.3 0.4Vp-p?
YES
OK
(3) Semi-fixed resistor on the APC PC board
The semi-fixed resistor on the APC printed circuit board
which is attached to the pickup is used to adjust the laser
power.Since this adjustment should be performed to match
the characteristics of the whole optical block, do not touch
the semi-fixed resistor.
If the laser power is lower than the specified value, the la-
ser diode is almost worn out, and the laser pickup should
be replaced. If the semi-fixed resistor is adjusted while the
pickup is functioning normally, the laser pickup may be
damaged due to excessive current.
www
.
http://www.xiaoyu163.com
YES
Normal
YES
Is 9V present at pin 24
of IC161?
NO
Is 9V present at pin 13
of IC901?
NO
Check IC901 and its
peripheral circuits.
NO
Replace it.
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Is the audio signal
(including sampling
YES
output components)
output to pins 1 and 7 of
IC581 during playback?
NO
Check IC581 and its
peripheral circuits.
YES Check the connections
between pin 24 of IC161
and pin 13 of IC901.
5.7 Replacement of laser pickup
Turn off the power switch and disconnect the
power cord.
Q Q
3 6 7 1 3 1 5
Replace the pickup with a normal one. (Refer
to "Removing the pickup unit" on the previous page.)
Plug the power cord in and turn the power on.
At this time, check that the laser emits for about
seconds and the objective lens moves up and down.
Note: Do not observe the laser beam directly.
Check the eye-pattern at
co
.
9 4 2 8
Is the audio signal output
YES
at pin 18 and pin 19 of
IC161 during playback?
NO
Check IC161 and its
peripheral circuits.
YES
Check the power
amplifier IC301.
0 5 8 2 9 9 4 2 8
Play a disc.
RF test point or
ARF test point.
m
Finish.
(No.MA255)1-29
9 9
9 9