JVC KD-SH1000J Service Manual page 12

QQ
3.1.8 Removing the front door mechanism assembly 3 7 63 1515 0
(See Fig.13)
• Prior to perform the following procedures, remove the front
panel assembly, heat sink, top chassis assembly and main
board.
(1) From the top side of the bottom chassis assembly, remove
the one screw N attaching the FPC guide to the bottom
chassis.
(2) Remove the five screws P attaching the front door mecha-
nism assembly to the bottom chassis.
Reference:
When attaching the screws N and P, apply a locking
agent them.
(3) Take out the front door mechanism assembly from the bot-
tom chassis.
3.1.9 Removing the switch board
(See Fig.14 to 16)
• Prior to performing the following procedures, remove the front
panel assembly.
(1) From the rear side of the front panel assembly, remove the
five screws Q attaching the rear cover to the front panel as-
sembly, (See Fig.14)
TE
L 13942296513
(2) Release the nine joints b of the front panel assembly and
remove the rear cover. (See Fig.15)
(3) Take out the switch board from the font panel assembly.
(See Fig.16)
Note:
When removing the rear cover assembly and switch board, be
careful not to lose the spring.
www
.
1-12 (No.MA255)
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Front door mechanism assembly
Bottom chassis
P
FPC guide
Q
Rear cover assembly
Q Q
3 6 7 1 3 1 5
Rear cover assembly
Joints b
Front panel assembly
co
.
Spring
9 4 2 8
P
N
Fig.13
Q
0 5 8 2 9 9 4 2 8
Q
Fig.14
Joints b
Joints b
Fig.15
Switch board
m
Fig.16
9 9
9 9