Daikin RXY5MY1 Operation Manual page 10

Press the on/off button.
2
The operation lamp lights up and the system
starts operation.
Adjustment
For programming temperature, fan speed and
air flow direction (only for the remote controller
BRC1A51: FXC, FXF, FXH, FXK, FXA), follow
the procedure shown below.
Press the temperature setting button and pro-
3
gram the desired temperature.
Each time this button is pressed, the tem-
perature setting rises or lowers 1°C.
NOTE
• Set the temperature within the operation
range.
• The temperature setting is impossible for fan
only operation.
Press the fan speed control button and select
4
the fan speed of your preference.
Press air flow direction adjust button.
5
Refer to the chapter "Adjusting the air flow
direction" for details.
Stopping the system
Press the on/off button once again.
6
The operation lamp goes off and the system
stops operation.
NOTE
• Do not turn off power immediately after the
unit stops, but wait for at least 5 minutes.
EXPLANATION OF HEATING OPERATION
Defrost operation
• In heating operation, freezing of the outdoor
unit coil increases. Heating capability
decreases and the system goes into defrost
operation.
• The indoor unit fan stops and the remote
controller displays "
• After maximum 10 minutes of defrost opera-
tion, the system returns to heating operation
again.
Hot start
• In order to prevent cold air from blowing out
of an indoor unit at the start of heating oper-
ation, the indoor fan is automatically
stopped. The display of the remote controller
shows " ".
5
6-2 PROGRAM DRY OPERATION
FOR SYSTEMS WITHOUT COOL/HEAT
CHANGEOVER REMOTE CONTROL SWITCH
(Refer to figure 5)
1
2
3
4
FOR SYSTEMS WITH COOL/HEAT
CHANGEOVER REMOTE CONTROL SWITCH
(Refer to figure 8)
1
2
3
".
4
5
• The function of this program is to decrease
the humidity in your room with a minimum
temperature decrease.
• The micro computer automatically deter-
mines temperature and fan speed.
• The system does not go into operation if the
room temperature is low.
Press the operation mode selector button sev-
eral times and select "
ation).
Press the on/off button
The operation lamp lights up and the system
starts operation.
Press the air flow direction adjust button (only
for FXC, FXF, FXH, FXK, FXA). Refer to the
chapter "Adjusting the air flow direction" for
details.
Stopping the system
Press the on/off button once again.
The operation lamp goes off and the system
stops operation.
NOTE
• Do not turn off power immediately after the
unit stops, but wait for at least 5 minutes.
Select cooling operation mode with the cool/
heat changeover remote control switch.
Press the operation mode selector button sev-
eral times and select program dry "
Press the on/off button
The operation lamp lights up and the system
starts operation.
Press the air flow direction adjust button (only
for FXC, FXF, FXH, FXK, FXA). Refer to the
chapter "Adjusting the air flow direction" for
details.
Stopping the system
Press the on/off button once again.
The operation lamp goes off and the system
stops operation.
NOTE
• Do not turn off power immediately after the
unit stops, but wait for at least 5 minutes.
" ( program dry oper-
".
English