Kenwood CD Player DP-SE7 Instruction Manual page 30

30
To repeat a recording
Return to the recording start position.
Press the rewind key during recording.
During recording
of top side
(while 3 is lit)
Automatic Adjustment of the Recording Level (CRLS)
A standard recording level has been set in advance for the cassette deck (X-SE7), but when the CRLS
function is used, the max. recording level is set automatically for the music source.
1 Play the contents to be recorded
(or receive the radio station to be recorded).
2 Press the CRLS key.
CRLS
Points for Recording from a CD or an MD
For recording from a CD or an MD, playback from
the music source and recording by the cassette deck
can be started simultaneously (synchro recording
function) when the cassette deck is set to record
pause status in advance.
Dolby HX Pro
The Dolby HX Pro headroom extension system records high frequencies such as the cymbal sound clearly by controlling
the bias current during recording according to the frequency composition of the sound being recorded. This system is
activated automatically during recording with this unit.
During recording of re-
verse side (while 2 is lit)
1 ¡
About 20 sec
CRLS CRLS
÷ If there is a non-recorded space of more than 4 seconds
before the recording start position, recording is aborted
and tape is rewound as shown below.
Tape stops after 2 sec. of transport.
Recorded tune
Blank of 4 sec. or more
÷ If there is no recorded tune before, the tape will be
rewound then stopped.
If the key has never been pressed
.....The sound is recorded with the basic level set with the
unit.
If the key is pressed
.....The recording level is set automatically and stored in
memory as the recording level to be used with the
current input being selected. From the next time on,
this recording level is set automatically for that input
even if the key is not pressed.
To return to the basic level
.....Hold the key depressed until the indicator goes off
(for approx. 3 seconds).
÷ The recording level setting completes in approx. 20
seconds, after which the deck enters the record-pause
mode.
÷ If recording is started during the setting (while the CRLS
indicator is blinking), distorted sound may be recorded.
÷ If a non-recorded space of more than 3 seconds is
detected after the CRLS key is pressed, the recording
level setting is aborted.
1 Pause the CD or MD to be played.
2 Use the skip keys (4 ¢) to select the title
to be recorded. (Pause will be reached at the
beginning of the selected title.)
3 Bring the cassette deck to recording pause
condition.
4 Start playback of the CD or MD.
(Synchro recording will start.)
÷ The recording is stopped when the stop key of the
playback unit is pressed.
Recording
R-SE7/DP-SE7/X-SE7 (En)
Tune to be re-recorded
Re-recording