Miele KM 6366-1 Operating And Installation Instructions page 42

Problem solving guide
Problem
After the hob has been
switched on  appears
in the timer display for a
few seconds.
The  symbol appears
in one or more cooking
zone displays and the
hob switches off auto‐
matically.
A cooking zone
switches off automati‐
cally.
A cooking zone
switches off automati‐
cally.
The Booster has deacti‐
vated early automatical‐
ly.
The cooking zone is not
working in the usual
way on the power set‐
ting selected.
Power level 9 is auto‐
matically reduced if you
select power level 9 on
two linked cooking
zones at the same time.
The food in the pan
does not heat up when
the Auto heat-up func‐
tion is switched on.
An operating noise can
be heard after the appli‐
ance has been switched
off.
42
Cause and remedy
The system lock has been activated.
 You need to deactivate the system lock (see "Sys‐
tem lock").
One or more of the sensors are covered, e.g. by fin‐
ger contact, food boiling over or an object.
 Clean off any dirt or remove the object (see "Safe‐
ty switch-off").
It has been operated for too long.
 You can use the cooking zone again by switching
it back on (see "Safety switch-off").
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
Operating both zones at power level 9 would exceed
the permitted maximum power for the two zones.
 Use a different cooking zone.
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
The fan will continue running until the appliance has
cooled down. It will then switch itself off automatical‐
ly.