Miele KM 6325-1 Operating And Installation Instructions page 36

Problem solving guide
Problem
After the hob has been
switched on  appears
in the display for a few
seconds.
The cooking zones do
not heat up.
A cooking zone
switches off automati‐
cally.
The Booster has deacti‐
vated early automatical‐
ly.
The cooking zone is not
working in the usual
way on the power set‐
ting selected.
Power level 9 is auto‐
matically reduced if you
select power level 9 on
two linked cooking
zones at the same time.
The food in the pan
does not heat up when
the Auto heat-up func‐
tion is switched on.
An operating noise can
be heard after the appli‐
ance has been switched
off.
36
Cause and remedy
Demonstration mode is activated.
 Turn the rotary control for the front left cooking
zone anti-clockwise and hold.
 Turn the rotary control for the right front cooking
zone twice briefly anti-clockwise and then turn an‐
ti-clockwise and hold until  appears in the
display.
It has been operated for too long.
 You can use the cooking zone again by switching
it back on (see "Safety switch-off").
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
Operating both zones at power level 9 would exceed
the permitted maximum power for the two zones.
 Use a different cooking zone.
A large amount of food is being heated up.
 Start cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a different pot or pan which conducts heat
properly.
The fan will continue running until the appliance has
cooled down. It will then switch itself off automatical‐
ly.