Kenwood KRF-X9050D Instruction Manual page 50

Remote control unit
50
Symptom
Subwoofer volume cannot be adjusted.
Remote control operation is not possible.
Cause
• Subwoofer is OFF.
• The remote control is set to a different operation
mode.
• Batteries are exhausted.
• The remote control unit is too far away from the
main system, controlling angle is too large, or
there is an obstacle between the receiver and
the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source component.
• An attempt is made to play a tape which is being
recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish to
control.
• The microprocessor of the remote control mal-
functions.
In case of difficulty
Remedy
• Turn the subwoofer ON.
• Press the source keys or source POWER keys
to select the appropriate operation mode.
• Replace with new batteries.
• Operate the remote control unit within the
controllable range.
• Connect properly referring to "Setting up the
system".
• Place software in the source component you
want to play.
• Wait until recording has completed.
• Press the source select keys or source POWER
keys to activate the operation mode for the
component you want to control before
operation
• Reset the microprocessor.
¡
)
8
fi
o