Listening To Radio Broadcasts; Tuning Radio Stations - Kenwood KRF-V6070D Instruction Manual

Recording
3 Press and hold the DIMMER key for more than 2 seconds to select
the A-REC or M-REC mode during digital input.
1 Rec mode off : The digital input record mode is switched off.
2 A-REC mode
: The digital input signals (DTS, Dolby Digital,
or PCM) are identified automatically and
converted into stereo signals that are ready
for recording.
3 M-REC mode : The input signal type at the moment this
mode is selected is held throughout this
mode.
For A-REC mode:
For M-REC mode:
4 Start playback, then start recording.
• If the audio reproduction stops in the middle due to change in the
input signals, etc., press the DIMMER key.

Listening to radio broadcasts

The receiver can store up to 40 stations in the memory and recall them
by one-touch operation.

Tuning radio stations

BAND AUTO
Multi % / fi
Tune – 1 / + ¡
Auto
1
Use the INPUT SELECTOR knob or TUNER key to select the
tuner.
2
Use the BAND key to select the desired broadcast band.
Each press switches the band
as follows:
1 FM
2 AM
3
Use the AUTO key to select the desired tuning method.
Each press switches the tuning method as follows:
1 AUTO lit (auto tuning)
2 AUTO not lit (manual tuning)
• Normally, set to "AUTO" (auto tuning). If the radio waves are weak
and there is a lot of interference, switch to manual tuning. (With
manual tuning, stereo broadcasts will be received in monaural.)
4
Use the MULTI CONTROL knob or Multi % / fi keys, or Tune
– 1 / + ¡ keys to select the station.
Frequency
display
Auto tuning : The next station is tuned automatically.
Manual tuning : Turn the knob (press the key) to select the desired
station.
MULTI CONTROL
INPUT SELECTOR
TUNER
+ +
¢
Band
4
+
"AM" or "FM" indicator
appears in the display
"AUTO" indicator lights
up in the display.
"ST." lights when
a broadcast is being
received in stereo.
"TUNED" is displayed
when a station is received.
21
EN