Kenwood KAC-PS650D Instruction Manual page 9

■ Power wire connection
A.CH FILTER B.CH
OFF
OFF HPF
HPF LPF
50 200
A.CH HPF
Lead terminal*
Battery wire*
Protective Fuse*
2WARNING
To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery's
positive terminal.
Wiring
•Take the battery wire for this unit directly from the battery. If it's connected to the vehicle's
wiring harness, it can cause blown fuses etc.
• If a buzzing noise is heard from the speakers when the engine is running, connect a line noise
filter (optional) to each of the battery wire.
• Do not allow the wire to directly contact the edge of the iron plate by using Grommets.
• Connect the ground wire to a metal part of the car chassis that acts as an electrical ground
passing electricity to the battery's negative - terminal. Do not turn the power on if the ground
wire is not connected.
• Be sure to install a protective fuse in the power cord near the battery. The protective fuse
should be the same capacity as the unit's fuse capacity or somewhat larger.
• For the power cord and ground, use a vehicle type (fireproof) power wring cord with a current
capacity greater than the unit's fuse capacity. (Use a power wiring cord with a diameter of 8
mm 2 (AWG 8) or greater.)
• When more than one power amplifier are going to be used, use a power supply wiring wire and
protective fuse of greater current-handling capacity than the total maximum current drawn by
each amplifier.
EXT.AMP.CONT. (external amplifier control) terminal )
1. Peel the cladding of wire for a length of 11mm from the end.
2. While pressing the lock release button with a slotted screwdriver, insert the wire.
11 mm
B.M.S. OPERATION INPUT SELECTOR
A
OFF A B A A B SUB
STEREO MONO(Lch)
REMOTE +12dB
L
GND
50 200 50 200 50 200
R
B.CH HPF B.CH LPF SUB.CH LPF
FILTER FREQUENCY(Hz)
POWER IN BRIDGED
SPEAKER
LEFT RIGHT
OUTPUT
BATT. P.CON
A
B
# $ %
Extension wire*
Ground wire*
Battery
The connecting wire diameter*
• If solid wire: Ø0.4 (AWG 26) – Ø1.2 (AWG 16)
• If multi strand wire: Ø0.4 (AWG 26) – Ø1.2 (AWG 16)
)
LINE IN
EXT.AMP.CONT.
B SUB
L
R
SUB
SUB
External amplifier control
wire (Pink / Black)
(Refer to page 7)
EXT.CONT.
CENTER UNIT
(CD receiver, etc.)
P.CONT.
Power control wire
(Blue/ White)
* : Commercially available parts
English
9