System Examples - Kenwood KAC-728 Instruction Manual

System examples

Full-range 2-channel system
KAC-728/528
OPERATION
FILTER
OFF LPF STEREO MONO(Lch)
KAC-628
OPERATION
FILTER
OFF L+R
HPF LPF STEREO MONO(Lch)
High-power full-range 2-channel system
KAC-728/528
OPERATION
FILTER
OFF LPF STEREO MONO(Lch)
KAC-628
OPERATION
FILTER
OFF L+R
HPF LPF STEREO MONO(Lch)
Full-range 2-channel + Subwoofer system
KAC-728/528
OPERATION
FILTER
OFF LPF STEREO MONO(Lch)
KAC-628
OPERATION
FILTER
OFF L+R
HPF LPF STEREO MONO(Lch)
Tri-mode
KAC-728/528
OPERATION
FILTER
OFF LPF STEREO MONO(Lch)
KAC-628
OPERATION
FILTER
L+R
OFF
HPF LPF STEREO MONO(Lch)
Principle of Tri-mode
Method of frequency band division using a coil and capacitor•••in case of 6dB/oct. slope
Crossover Frequency
0 dB
-3 dB
L
Example:
When it is required to set a crossover frequency of 120 Hz using speakers with an
impedance of 4 ohms.
Prepare commercially-available coil and capacitor with the closest ratings to the results
calculated from the formula above. The capacitor rating should be as close as possible to 331.25
(µF) and the coil rating should be as close as possible to 5.3 (mH).
2CAUTION
• If you wish to bridge-connect a speaker, the speaker impedance must be no less than 4 ohms.
Connecting a speaker with an impedance lower than 4 ohms may damage the unit.
• Be sure to connect capacitors to speakers to which high frequencies will be passed. Failure to
do so will result in a drop of the combined impedance with the subwoofer.
• Ensure that the withstand voltage and current ratings of the capacitors (C) and coils (L) are
sufficient.
10
CENTER UNIT
Switch setting
CENTER UNIT
Switch setting
CENTER UNIT
Switch setting
CENTER UNIT
Switch setting
Coil (L): Passes low frequencies and blocks high
Capacitor (C): Passes high frequencies and blocks low
C
C=
Frequency
L=
L L
R R
L
L L
R R
L L
R
R R
L L
R R
C
High
L L
pass
R R
C
frequencies. (Low pass)
frequencies. (High pass)
159000
(µF)
fc=Cut of Frequency (Hz)
fc x R
R=Speaker Impedance (Ω)
159 x R
(mH)
fc
Left speaker
Right speaker
Left speaker (Bridged)
Right speaker (Bridged)
Left speaker
Right speaker
Subwoofer
(L + R)
(Bridged)
L
Subwoofer
(L + R)
(Bridged)