Table of Contents
Advertisement
System examples
■ 4-channel system
L
A
CENTER UNIT
R
L
B
R
■ 2-channel + Subwoofer system (1)
L
CENTER UNIT
A
R
L
B
R
■ Tri-mode
(High pass)
L
A
CENTER UNIT
R
L
B
R
6
English
Front Left speaker
L
Front Right speaker
R
Rear Left speaker
L
R
Rear Right speaker
Left speaker (High pass)
L
Right speaker (High pass)
R
Subwoofer
L
(Bridged)
R
Subwoofer
(L + R) (Bridged)
C
L
L
R
C
C
L
L
R
C
Autogood products Internet store "130"
■ High-power 2-channel system
CENTER UNIT
■ 2-channel + Subwoofer system (2)
CENTER UNIT
Principle of Tri-mode
Method of frequency band division using a coil and capacitor...in case of 6dB/oct. slope.
Crossover Frequency
0 dB
-3 dB
L
Frequency
159 x R
159000
C=
L=
(mH)
fc
fc × R
Example:
When it is required to set a crossover frequency of 120 Hz using speakers with an
impedance of 4 ohms.
Prepare commercially-available coil and capacitor with the closest ratings to the
results calculated from the formula above. The capacitor rating should be as close as
possible to 331.25 (μF) and the coil rating should be as close as possible to 5.3 (mH).
2CAUTION
• If you wish to bridge-connect a speaker, the speaker impedance must be no less
than 4 ohms. Connecting a speaker with an impedance lower than 4 ohms may
damage the unit.
• Be sure to connect capacitors to speakers to which high frequencies will be passed.
Failure to do so will result in a drop of the combined impedance with the subwoofer.
• Ensure that the withstand voltage and current ratings of the capacitors (C) and coils
(L) are sufficient.
L
L
L
Left speaker (Bridged)
A
R
R
L
L
R
Right speaker (Bridged)
B
R
R
Left speaker (High pass)
L
L
A
R
Right speaker (High pass)
R
Subwoofer
L
L
B
(Bridged)
R
R
Coil (L):
Passes low frequencies and blocks high
frequencies. (Low pass)
Capacitor (C):
Passes high frequencies and blocks low
C
frequencies. (High pass)
fc=Cut of Frequency (Hz)
(μF)
R=Speaker Impedance (Ω)
Advertisement
Table of Contents
