Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Kenwood KAC-718
Summary of Contents for Kenwood KAC-718
- Page 1 KAC-718 MONO POWER AMPLIFIER INSTRUCTION MANUAL © B64-1357-00 (EM)
-
Page 2: Safety Precautions
• To prevent a short circuit when replacing a fuse, first disconnect the wiring harness. NOTE • If you experience problems during installation, consult your Kenwood dealer. • If the unit does not seem to be working right, consult your Kenwood dealer. English... -
Page 3: Installation Procedure
Installation procedure 1. Remove the ignition key and disconnect the negative - terminal of the battery to prevent short circuits. 2. Set the unit according to the intended usage. 3. Connect the input and output cables of the units. 4. Connect the speaker cables. 5. -
Page 4: Input Sensitivity Control
Controls Operations of the following control and switches are required in accordance with the center unit and speakers connected with this unit. LINE IN INPUT SENSITIVITY(V) 1 RCA cable ground lead terminal 2 LINE IN terminal 3 INPUT SENSITIVITY control Set this control according to the pre-output level of the center unit connected with this unit, or to the maximum power output of the genuine- accessory car stereo. -
Page 5: Protection Function
Protection function This unit is equipped with a protection function for protecting this unit and your speakers from various accidents or problems that can occur. When the protection function is triggered, the Power indicator goes off and the amplifier stops operating. Power indicator: When the power is turned on, the Power indicator lights. - Page 6 Connection RCA cable connection 2CAUTION Do not connect cables and leads to both RCA cable input jacks and the speaker input terminals simultaneously, for this may cause malfunction or damage. Left input LINE IN RCA cable ground terminal When using an RCA cable with a ground lead attached, connect the ground lead to this terminal.
- Page 7 Power wire connection LINE IN INPUT SENSITIVITY(V) Round terminal (Medium) Power control cable (Commercially available part) Battery cable (Commercially available part) Protective Fuse 2WARNING To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery’s positive terminal.
-
Page 8: Troubleshooting Guide
Troubleshooting Guide What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. PROBLEM No sound. (No sound from one side.) The output level is too small (or too large).