Parent Unit; Using The Appliance - Philips AVENT AVENT SCD525 User Manual

4.2 Parent unit

4.2.1 Operation on rechargeable batteries
The parent unit comes with two rechargeable
NiMH AAA 850mAh batteries.
Charge the parent unit before you use it for the
the batteries are low (the empty battery symbol
The parent unit starts indicating that the batteries
are low 30 minutes before the batteries are
completely empty.
D
Note:
If the batteries are completely empty, the parent
unit automatically switches off and loses contact
with the baby unit.
Remove the lid of the compartment for the
1
rechargeable batteries (Fig. 6).
Insert the rechargeable batteries (Fig. 7).
2
D
Note:
Make sure the + and - poles of the batteries
point in the right direction.
Reattach the lid (Fig. 8).
3
Insert the small appliance plug into the
4
charger, put the adapter in a wall socket and
place the parent unit in the charger (Fig. 9).
Leave the parent unit in the charger until the
5
batteries are fully charged.
When you charge the parent unit for
disuse, switch it off and let it charge
continuously for at least 10 hours.
8
T
Charging normally takes 8 hours, but
it takes longer when the parent unit is
switched on while charging. To keep the
charging time as short as possible, switch
off the parent unit during charging.
When the batteries are fully charged, the
parent unit can be used cordlessly for up
to 24 hours.
D
Note:
time, the operating time is less than 24 hours. The
batteries only reach their full capacity after you
have charged and discharged them four times.
D
Note:
When the parent unit is not in the charger, the
batteries gradually discharge, even when the
parent unit is switched off.

5 Using the appliance

Place the parent unit and the baby unit in the
1
same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3.5
feet away from the parent unit.
Press and hold the on/off button 3 on the
2
baby unit until the green power-on light goes
on. (Fig. 11)
D
Note:
The power-on light always lights up green,
even when there is no connection with the
parent unit.
Press and hold the on/off button 3 on the
3
parent unit until the sound level lights light up
T