Philips AVENT SCD520 Troubleshooting Manual

TROUBLE SHOOTING GUIDE
Philips Avent SCD520/00 Monitor 955019
Supplier: Philips Avent
Product: DECT BABY MONITOR SCD520 DECT BABY MONITOR
SKU: 955019 (Philips Avent SKU - SCD520/00)
Style No: G1331
POWER / LINKING
1. Q: Why don't both the power-on light of the baby unit and the LINK light of the parent unit come on
when I press the on/off buttons of the units?
A: Perhaps the battery pack of the parent unit is empty and the parent unit is not in the plugged-in
charger. Insert the small appliance plug into the charger, put the adapter of the charger in a wall socket
and place the parent unit in the charger. Then press the on/off button to establish connection with the
baby unit.
A: Perhaps the non-rechargeable batteries of the baby unit are empty and the baby unit is not
connected to an electrical outlet. Replace the non-rechargeable batteries or connect the baby unit to an
electrical outlet. Then press the on/off button to establish connection with the parent unit.
A: The baby unit and the parent unit may be out of range of each other. Move the parent unit closer to
the baby unit, but not closer than 3 feet/1meter. If the LINK light on the parent unit still does not start to
flash, use the reset function to reset the units to their default settings.
2. Q: Why does the LINK light on the parent unit light up red continuously and why is the message 'Not
Linked' shown on the display?
A: The baby unit and the parent unit are out of range of each other. Move the parent unit closer to the
baby unit. The baby unit may be switched off. Switch on the baby unit.
3. Q: Why does the battery light on the baby unit flash red?
A: The non-rechargeable batteries of the baby unit are running low. Replace the non-rechargeable
batteries or connect the baby unit to an electrical outlet.
4. Q: Why does the parent unit beep?
A: If the parent unit beeps while the LINK light lights up red continuously and the message 'Not Linked'
is shown on the display, the connection with the baby unit is lost. Move the parent unit closer to the baby
unit.
A: If the parent unit beeps and the battery symbol on the display is empty, the rechargeable battery
pack of the parent unit is running low. Recharge the battery pack.
A: If you have switched off the volume while the sound alert is on, the parent unit beeps whenever the
fourth sound level light lights up because the baby unit has picked up a sound.
A: If you have set the room temperature range on the parent unit and the temperature alert is on, the
parent unit beeps when the temperature drops below the set level or below 57°F (14°C) or when the
temperature rises above the set level or above 86°F (30°C).
A: The baby unit may be switched off. Switch on the baby unit.