System Setup Menu; Advanced Setup Menu - BenQ W7000+ User Manual

System Setup menu

Function
Language
Splash Screen
Projector Position
Auto Off
Sleep Timer
Menu Settings
Input Source
Source Rename
Auto Source Search

Advanced Setup menu

Function
Lamp Settings
HDMI Settings
Baud Rate
Test Pattern
44 Using the projector
Sets the language for the On-Screen Display (OSD) menus. See
menus" on page 22 for details.
Allows you to select which logo screen will display during projector start-up.
You can choose BenQ logo screen, Blue screen or Black screen.
The projector can be installed on a ceiling or behind a screen, or with one or
more mirrors. See "Choosing a location" on page 12
Prevents unnecessary projection when no signal is detected for a long time. See
"Setting Auto Off" on page 47
Sets the auto-shutdown timer. The timer can be set to a value between 30
minutes and 3 hours.
Menu Display Time
Sets the length of time the OSD will remain active after your last key press.
Menu Position
Sets the On-Screen Display (OSD) menu position.
Selects an input source to be projected. See
page 21 for details.
Renames the source to your desired name. See
page 21 for details.
Sets whether the projector searches automatically for input sources. If the
source scan is On, the projector will scan for input sources until it acquires a
signal. If the function is not activated, the projector selects the last used input
source.
Reset Lamp Timer
Once the lamp is renewed, select Reset to return the lamp timer to "0". See
"Resetting the lamp timer" on page 50
Equivalent Lamp Hour
Shows the lamp hour information. See
page 47 for details.
HDMI Format
Selects an input source type for the HDMI signal. You can also manually select
the source type. The different source types carry different standards for the
brightness level.
HDMI Format is only available when the HDMI signal is selected.
CEC
Enables or disables the CEC function. When you connect an HDMI CEC-
compatible device to your projector with an HDMI cable, turning on the HDMI
CEC compatible device automatically turns on the projector, while turning off
the projector automatically turns off the HDMI CEC compatible device.
Selects a baud rate that is identical with your computer's so that you can
connect the projector using a suitable RS-232 cable and update or download
the projector's firmware. This function is intended for qualified service
personnel.
Press ENTER to display the grid test pattern. It helps you adjust the image size
and focus and check that the projected image is free of distortion.
The function is only available when the projector detects no input signal.
http://www.pureglare.com.au
Description
for details.
for details.
"Selecting an input source" on
"Selecting an input source" on
Description
for details.
"Getting to know the lamp hour" on
"Using the