The Description Of Front Panel And Display Lamp; Lcd Panel Section; Led Indicators Function - ICA SE1000 Operating Manual

Gbr. 4.Mode Bypass
4.2.2. Mode Utility
Pada mode utility, penunjukkan display seperti gambar berikut:
Gbr. 5.Mode Utility
LED hijau nyala, display LCD: Statusnya "on line".
o Jika muncul pesan "INPUT" pada display (baris kedua pada display LCD)
berkedip, itu menunjukkan sambungan fase dan netral tidak benar.
o Jika penunjuk grafis kapasitas beban pada display (baris ketiga pada display
LCD) berkedip, LED kuning nyala dan buzzer berbunyi tiap setengah detik,
ini menunjukkan beban pada UPS melebihi 100% dan sebaiknya lepaskan
beberapa beban sampai tampilan beban dibawah 100%.
o Jika penunjuk grafis kapasitas batterai pada display (baris ketiga pada
display LCD) berkedip, LED kuning nyala, ini menunjukkan UPS tidak
terhubung dengan batterai atau tegangan batterai rendah, dan sebaiknya
pertamakali periksa apakah koneksi batterai sudah benar, jika ya, batterai
mungkin rusak dan perlu untuk diganti.
Anda dapat menekan tombol function selama 1 detik untuk melakukan self-
test secara manual, untuk lebih jelasnya lihat table ketidak normalan.
VAC HZ
OUTPU T
VAC HZ
OUTPU T
Hal 9

3.4. The Description Of Front Panel And Display Lamp

88.8 88.8 VDC
KW
VAC
IN PUT (R ST) B ATTERY OUTPU T LOAD TEMP
8 8
Fig. 3. Description of the front panel

3.4.1. LCD panel section

o The first line is the numeric section, and is consisted of two small numeric
sections and the related unit section on the right side. It is used to display
the numerical value of the certain item on the second line.
o The second line is the section of the items which include input, battery,
output, load and temperature, etc.
o The third line is the graphic section which has the load (left) and battery
capacity (right) displayed in graphics. The failure icon will be displayed
when there is a failure.
o The fourth line is the status section, and is the area of machine status in
English. The utility mode is displayed as "on line". The battery mode is
displayed as "on batt". The bypass mode is displayed as "on bps".

3.4.2. LED indicators function

o Red LED is on
UPS is fault and has no output. For example; Overload beyond the allowed
time, inverter fault, BUS fault, over temperature fault, etc.
o Yellow LED is on
UPS is alarming. For example; With utility in but not turn on the UPS,
Bypass mode, batteries are over charged, charger fault, fan stop working,
batteries are discharged to battery low voltage when UPS works on battery
mode.
o Green LED is on
UPS is normally powered by utility or battery inverter mode.
LED Green light
LED Yellow light
LED Red light
C%
KVA
HZ
8 8 8
Page 6