I. SAFETY NOTES / CATATAN KESELAMATAN I.1. Electrical Safety ● Do n ot work alone under hazardous conditions. ● High current through conductive materials could cause severe burns ● Check that the power cord (s), plug(s), and socket are in good condition. ●...
Page 4
I.3. Battery Safety ● Repair are to be performed only by qualified personnel ● Do not dispose of batteries in a fire. The batteries may explode. ● Do not open or mutilate batteries. They contain an electrolyte that is toxic and harmful to the skin and eyes.
II. INTRODUCTION / PENDAHULUAN The ICA Uninterruptible Power Supplies is an advanced true on-line sinewave with technology high voltage PWM (Pulse Width Modulation) and static transfer switch. The UPS can provide reliable, regulated, transient free AC power to sensitive equipment ranging from computers &...
Page 6
II.1. DIAGRAM BLOCK VIEW / GAMBAR BLOK DIAGRAM INVERTER RECTIFIER AC INPUT INDICATOR CHARGER & CONTROL TO COMPUTER NETWARE BATTERY UPS SIN1100C, UPS SIN1500C RECTIFIER INVERTER AC INPUT INDICATOR CHARGER & CONTROL TO COMPUTER NETWARE EXTERNAL BATTERY (OPTION) BATTERY EXTERNAL BATTERY (OPTIONAL) UPS SIN2100C...
IV. FRONT PANEL & REAR PANEL VIEW / TAMPAK PANEL DEPAN & PANEL BELAKANG FRONT PANEL VIEW REAR PANEL VIEW UPS SIN1100C, SIN1500C REAR PANEL VIEW REAR PANEL VIEW UPS SIN2100C UPS SIN3100C...
Page 9
1. Panel Monitor 2. Ventilation / Lubang Angin 3. MCCB 1 4. MCCB 2 5. Communication port / Port Komunikasi 6. Fuse Output 7. Fuse Static Switch 8. Outlet / Stopkontak Output 9. Input AC Cable / Kabel AC Input 10.
Page 10
IV.1. PANEL MONITOR 1. Mains : Green led, indicate AC Power ON / Led hijau, menunjukkan PLN ada. 2. Inverter On : Green led, indicate Inverter ON / Led Hijau, menunjukkan Inverter bekerja. 3. Bypass Output: Yellow led, indicate output from AC input through Static Transfer Switch / Led Kuning, menunjukkan output...
Do not blocking the airflow intake/ exhaust and retain 10 cm between wall and others equipment. 2. Installation a. It is recommended that UPS (SIN1100C & SIN1500C) connect to outlet which have 15 Amp safety circuit breaker. b. UPS SIN-2100C, SIN-3100C have standard terminal block and needs wiring that connect the UPS to power line even with sensitive load.
Page 12
V. UPS INSTALLATION / PEMASANGAN UPS 1. High voltage DC at external battery terminal, although all the circuit breaker “OFF” don’t touch this terminal battery. 2. Because there is a high voltage, installation must be done by technician. 3. Make sure circuit breaker at “OFF” position before wiring installation. 4.
VI. UPS START UP / MENGHIDUPKAN UPS a. Make sure all the circuit breaker is in the “OFF” position and no load is connected to the Output UPS. b. Turn on all the circuit breaker, indicator “MAINS” and “BYPASS” will light on. c.
VII. OPERATION PROCEDURE / CARA PENGOPERASIAN 1. Turn on procedure a. Turn on all the circuit breaker on the back panel. b. Push the “ON” switch on the front panel. c. Turn on the load that are connected to the output. 2.
VIII. TABLE OF INDICATOR STATUS / TABEL STATUS INDIKATOR INVERTER OVER STATUS RECOMMENDED MAINS BYPASS FAULT BUZZER OUTPUT LOAD CONDITION SOLUTION Every 30 UPS not running Push “ON” switch seconds Normal Every 4 Normal, utility seconds Power failure Normal, battery will Every 1 Close your software discharge...
IX. TROUBLE SHOOTING GUIDE / PETUNJUK KETIDAK NORMALAN RECOMMENDED SYMPTOM PROBABLE CAUSE SOLUTION “MAINS” and “BYPASS” indicators UPS not running Turn on the UPS are ON “MAINS”, 1. Remove some load from the “OVERLOAD” and Overload “BYPASS” indicators 2. If it remains the situation, call are ON for service 1.
Page 17
SERVICE CENTRE Jln. Pinangsia Raya I No: 22BB Jakarta - 11120 Phone : (021) 6906020 (Hunting) Notes : For further information, please visit “www.icaups.co.id”. ---------------------------------------------------------------------------------- Catatan : Untuk informasi lebih lanjut, silakan kunjungi “www.icaups.co.id”.