Fault Mode - ICA SE1000 Operating Manual

4.2.4. Fault mode

The front panel indication and display is as following:
Fig.7.Fault mode
Red LED is on, LCD displays: Status is Fault indication mark as the marker in the
figure above. The digital section indicates the fault code, and there is some simple
fault information in the status section. For more details please refer to the abnormal
process table.
Notice:
o The following process must be performed if the UPS is connected
with generator:
First turn on generator, after it runs stably (at this time ensure UPS
is no-load connected) connect output power of generator to UPS
input terminal, then turn on UPS. After UPS turn on, please connect
load one-by-one.
o It is recommended that the generator capacity is as twice as UPS
rated capacity.
5
Page 11
3.3. Panel Belakang UPS
COMMUNICATIO N
INTERFACE
FAN
INP UT
BREAKER
NET S URG E
PROTE CTION
INP UT
SO CKE T
Gbr. 1. Panel Belakang SE1000
BATTE RY
SO CKE T
INTERNAL
SNMP SLOT
OUTPUT
Hal 4