Kenwood eXcelon KAC-X1R Instruction Manual page 5

■ Multi Amplifier with Remote cable connection ( Accessory of KAC-PS1D. Optional accessory for KAC-X1R.)
You can control the Bass boost level of the second
and subsequent Slave amplifiers simultaneously
from the Master amplifier.
The volume level of each amplifier is determined
by the setting of the Master amplifier (INPUT
SENSITIVITY, boost level of the remote controller).
Setting the Master amplifier
1. Adjust the "INPUT SENSIVITY" to the output of
the center unit to be connected.
2. Set the LPF frequency and Bass boost level.
3. Turn the "LINE OUT FILTER" switch "ON".
Setting the Slave amplifier
1. Turn the "LINE OUT FILTER" switch "OFF".
2. Adjust the "INPUT SENSIVITY".
• To adjust the Slave amplifier to the same
volume as the Master amplifier, adjust the
"INPUT SENSIVITY" to "0.2 V (max.)".
2CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level knob
all the way to the left.
* Commercially available parts
CENTER UNIT
(CD receiver, etc.)
Power control wire
100
LPF
70
ON
40
LPF
OFF
FREQUENCY(Hz)
FUSE (25A 3) POWER IN
Master amplifier
Extension wire*
FUSE (25A 3) POWER IN
Slave amplifier
FUSE (25A 3) POWER IN
Slave amplifier
RCA cable*
1
150
2
3
0.5
4
200 (MIN)5 0.2(MAX)
INPUT
SENSITIVITY(V)
SPEAKER OUTPUT
LINE OUT FILTER
OFF ON
REMOTE RESET LINE IN
LINE OUT FILTER
OFF ON
1
100 150
LPF
70 2
ON
3 0.5
4
40 200 (MIN)5 0.2(MAX)
LPF INPUT
OFF
FREQUENCY(Hz) SENSITIVITY(V)
SPEAKER OUTPUT
LINE OUT FILTER
OFF ON
REMOTE RESET LINE IN
LINE OUT FILTER
OFF ON
1
100 150
LPF
70 2
ON
3
0.5
4
40 200 (MIN)5 0.2(MAX)
LPF INPUT
OFF
FREQUENCY(Hz) SENSITIVITY(V)
SPEAKER OUTPUT
LINE OUT FILTER
OFF ON
REMOTE RESET LINE IN
LINE OUT FILTER
OFF ON
Remote cable
Remote controller
LINE OUT
RCA cable*
LINE OUT
LINE OUT
English 5