Related Manuals for Team Electronic PT617A
Summary of Contents for Team Electronic PT617A
- Page 1 PT617A ( VHF ) PT618A ( UHF ) Mobilfunkgerät Mobile Transceiver Bedienungsanleitung Manual...
-
Page 2: Table Of Contents
Dear customer, CONTENTS page 1. Unpacking and Checking Accessories The following instructions will help to prolonge your radios life. 2. Preparation 2.1 Power Cable Connection Do not expose the transceiver for a long period to direct sunlight, nor 2.2 Radio Installation 22 - 23 place the transceiver close to heating appliances. -
Page 3: Unpacking And Checking Accessories
1. Unpacking and Checking Accessories Mark the position of the mounting bracket and drill holes on the instru- Please take out the transceiver from the packing box carefully. You are ment panel. And then fix the mounting bracket, the flat washer and the advised to check the supplied accessories according to the following list, spring washer with 4 M5 16 tapping screws. -
Page 4: Aerial Connection
2.4 Aerial Connection 3.2 Display Before pressing the transmit key, a suitable aerial must be connected. The BNC-plug of the aerial cable has to be connected to the socket on the rear panel. Make sure, that all plugs are firmly tightened and properly soldered. -
Page 5: Setting Squelch Level
4.2 Setting the Squelch Level 5.3 Transmitting Operation You may select the proper squelch level , and there are 10 levels (0~9) Make sure the selected channel is free before transmitting. You may selectable in all. If level 0 is set, the squelch will be turn off complete- press the PTT key and speak to the microphone after the LED lights ly. -
Page 6: Time-Control
6.4 Time-Control TOT Reset Time The radio will restart the scan after pausing for some time while receiv- TOT Reset Time sets the minimum wait time allowed between trans- ing signal .The pausing time can be preset from 0.5 to 5 seconds. missions that will reset the Time-Out -Timer. -
Page 7: 2-Tone Signaling
When receiving the signals with proper DTMF code, the squelch will The dealer can program that the squelch turns half active certain be activated, and you can receive the call. time after the signal disappears. The LED flashes orange. If auto reply has been set, the calling radio will receive confirming signals. -
Page 8: Repeater Signals
C. Hold the A key for about 1 second to light dELA on LCD and delete 7.12 Repeater Signals all channels data. Then press A key to delete the selected channel 1) Transmitting Beginning/Ending signals are used to join in or discon- data and return to CH 01.Or press B key to cancel the deleting of nect from some repeaters and calling systems. -
Page 9: Trouble Shooting
Cannot turn on or display is dim. General Power cable connection is not correct. Please connect the power Frequency Range PT617A: 136 - 174 MHz, PT618A: 440 - 480 MHz Channels cable over again. Channel space 25 kHz / 12.5 kHz PLL steps 5 / 6.25 / 12.5 / 25 / 1000 KHz... - Page 10 WEEE - Reg. Nr. DE 91930360 8 ( EAR ), 50635 ( ERA ) DSD 2617305, ARA 2284 TEAM Electronic GmbH Bolongarostrasse 88; D-65929 Frankfurt am Main, Germany phone ++49 / 69 / 300 950 0 - fax ++49 / 69 / 31 43 82...